Overview
24VDC @ 10A Power Supply/Charger, FAI, Aux Output

eFlow104N is a power supply/charger that converts a 120VAC 60Hz input into a single 24VDC output with a total of 10A max. The unit includes an unswitched aux. output. It also offers a suite of features that includes fire alarm disconnect, over voltage protection, and low power disconnect which prevents deep discharge of stand-by batteries.
Features:
- Input
- 120VAC, 60Hz, 4.5A
- Input fuse: 5A/250V
- Output
- 24VDC @ 10.0A supply current
- Auxiliary Power-Limited output rated @ 1A (unswitched)
- Over Voltage Protection
- Battery Charging
- Built-in charger for sealed lead acid or gel type batteries
- Maximum charge current: 1.0A
- Automatic switch over to stand-by battery when AC fails
- Transfer to stand-by battery power is instantaneous with no interruption
- (Batteries are sold separately)
- Supervision
- AC fail supervision (form "C" contacts)
- Notification trigger is selectable for 30 seconds (factory set) or 2 hours
- Battery fail & presence supervision (form "C" contacts)
- Low power shutdown. Shuts down DC output terminals if battery voltage drops below 70-75% (depending on the power supply). Prevents deep battery discharge
- Fire Alarm Disconnect
- Supervised Fire Alarm disconnect (latching or non-latching) 10K EOL resistor. Operates on a normally open (NO) or normally closed (NC) trigger
- Short circuit and overload protection
- Unit is complete with power supply, enclosure, battery leads and cam lock