Surface Mount Pool Access Alarm

The PAA can be operated with an on-board 9 volt lithium battery or with a 12 volt externally supplied DC power source, in which case the battery will perform a back-up function should the externally supplied source fail for any reason. Both power sources have been designed to maintain a minimum sound pressure level of 85db at 10’. Should the battery voltage drop below 8.3 Volts, a low battery mode will be initiated and the unit will beep approximately every 50 seconds. Battery must be replaced at this time.

Features:

• ETL tested to be in compliance with standard safety, UL 2017, and Florida Building Commission Code requirements, per ETL listing number 3035022
• Exceeds operational requirements of model barrier codes
• Microprocessor controlled
• Monitors entry to pool and spa areas
• Options set by jumpers include closed or open loop, instant on or 7 second delay alarm, and 15 or 7 second adult shunt
• Child resistant button guard built in
• Surface or flush mount models
• Capable of 2 year life with lithium battery
• May be hard wired to remote 12 Volt 500 mA power source, applied voltage must not exceed 15 VDC